...
- Port: Select a serial port to configure. Most standard serial devices enumerate on port 0 (on the HO523, they will enumerate on port 1). If you are connecting a USB-serial device (such as a GPS receiver), it will enumerate on port 2.
- GPS Receiver: Check this box if the port is being used to connect a USB-serial GPS device to the player.
- Baud rate: Set the baud rate for serial communications on the port.
- Data bits: Set the number of data bits.
- Parity: Set the parity.
- Stop bits: Select the number of stop bits.
- Protocol: Determine whether the serial data is formatted as Binary or ASCII.
- Send EOL: Select the end-of-line character when sending data to a serial device.
- Receive EOL. Select the end-of-line character when receiving data from a serial device.
- Invert Signals: Check this box to invert the TX/RX signal levels on the serial port. This allows the player to communicate with devices that use -12V to 12V signaling. Inversion is supported on the DE9 the DE-9 (more commonly referred to as DB-9) and USB ports only.
UDP
Use this section to configure UDP communications:
...