Versions Compared
Key
- This line was added.
- This line was removed.
- Formatting was changed.
This object allows you to emulate USB HID devices, but currently, the only supported type of device is a USB keyboard.
When operating on an XT1145 or XT2145 on BOS version 9.0.157 or later, this code must be added in order to use this object:
| Code Block | ||
|---|---|---|
| ||
'updated code needed for new firmware
dc=CreateObject("roDeviceCustomization")
dc.ConfigureAsUsbGadget(1) |
BrightSign players with USB-C (except for LS3 and LS4) can use this object.
| Warning |
|---|
Important USB keyboard codes are different from PS/2, ASCII, and BrightSign keyboard codes. |
ifUsbHidEmulator
Enable() As Boolean
Enables the HID device. This method returns true on success. If there's a failure, use GetFailureReason() to
...
get the reason for the failure.
KeyDown(a As Integer) As Boolean
Sends a
...
keydown event for the specified USB key code. This method returns true on success.
...
| title | Note |
|---|
If there's a failure, use GetFailureReason() to get the reason for the failure.
USB keyboards only have 6-key rollover, therefore only six keys can be down at one time.
KeyUp(a As Integer) As Boolean
Sends a
...
keyup event for the specified USB key code. This
...
method returns true on success, and returns fails on failure (e.g. if the specified key was not already down). If there's a failure, use GetFailureReason() to get the reason for the failure.
KeyPress(a As Integer) As Boolean
Equivalent to KeyDown(key code) followed by KeyUp(key code).
...
This method allows you to avoid leaving keys stuck down.
Clear() As Boolean
Clears all active keystrokes and modifiers.
GetModifierState() As Object
Returns an associative array with the current state of all modifiers (i.e. shift, alt, ctrl).
SetModifierState(a As Object) As Boolean
Sets the current modifier state as specified by an associative array
...
. Only modifiers that are listed will cause the state to change. Modifiers will
...
persist until changed
...
or Clear() is called.
Example
| Code Block | ||
|---|---|---|
|
...
...
hidkey.SetModifierState({ LeftShift : true }); |
GetLedState() As Object
Returns an associative array with the current state of all LED states on the keyboard.
...
The host may send an LED state change
...
if a lock key (i.e. Number Lock, Capital Lock, Scrolling Lock) is pressed, generating theroUsbHidLedEmulatorEvent object. The GetLedState() method can be used to get the current LED state without using an event.
ifUserData
SetUserData(user_data As Object)
Sets the user data that will be returned when events are raised.
GetUserData() As Object
Returns the user data that has previously been set via SetUserData(). It will return Invalid if no data has been set.
ifMessagePort
SetPort(port as roMessagePort)
Posts messages of type roUsbHidEmulatorLedEvent to the attached message port.
ifFailureReason
GetFailureReason() As String
Returns additional information if
...
a method fails.