XTx44 Theory of Operation

This section describes how specific components operate on the XT244 and XT1144.

On-Board LEDs

There are four on-board LEDs that indicate the following:

LED	Indication

LED	Indication
Green power (Pwr)	Displays when the board is powered up and not in reset mode. Flashes during the firmware update process.
Green file-system activity (Bsy)	Flashes any time there is file-system activity (on any storage device)
Blue WiFi ()	Flashes when the player is connecting to the wireless network. Displays when connected.
Red status (Err)	Flashes a certain number of times to indicate which error is occurring. The flash codes are described below.
	2	Unspecified error
	3	Network recovery script is preparing to run on a device configured for network recovery.
	4	No upgrade file found.
	5	Failed to load kernel module.
	6	Board is not capable of running the current firmware version.
	7	A piece of on-board hardware is not working correctly.
	8	Problem related to the storage device (either the USB drive or microSD card)
	9	Problem related to the registry/NAND
	10	The autorun script encountered a load/run error.
	11	WiFi-related error
	12	Unable to find a bootable image.
	13	The root file system has failed verification, which is used to detect whether the file system has been tampered with. You can recover a player that is showing this error code by performing a firmware update with secure boot.
	14	Boot loader failure
Red alternate*	2	Erase failed
	3	Write failed
	4	Verify failed
	5	Failed to find UBI partition
	6	Attempt to write unsigned CFE to unit with secure boot enabled
	7	Failed to find UBI partition
	8	Failed to create/attach UBI partition
	9	Unexpected error
	10	Upgrade script exited abnormally
	11	Upgrade took longer than expected
	12	Update completed but update file could not be deleted
	13	Firmware update file could not be read (from firmware v5.1.40)

*The red status LED may give one long initial flash to preface an alternate code, described at right

Service Button

The Service (SVC) button provides a dedicated GPIO button (GPIO12) for the OS. Pressing the SVC button pulls the pin low. Conversely, releasing the button pulls the pin high.

Reset Button

The Reset button is connected to the reset circuit. Pressing down the Reset button will send an initial signal to the system software, and holding the reset button low for approximately 4 seconds will cause a hard reset.

microSD Slot

The XT244 and XT1144 have one microSD slot, which supports transfer modes up to UHS-1 DDR50 (50MB/s). There is no inherent limit on the storage capacity of microSD cards used with the player.

Wireless Module

The XT244 and XT1144 have an internal M.2 (key E) slot for installing a compatible wireless module. The M.2 wireless module connects via cables to two external, attachable wireless antennas.

SSD Module

The XT244 and XT1144 have an internal M.2 slot (key M) slot for PCIe (NVMe) SSD drives. See this page for a full list of SSD specifications.