XD5 Environmental and Power Usage
- BrightSign TechDocs
The XD235 and XD1035 are designed for sustained ambient temperatures between 0°C and 50°C. Non-operational (transportation or storage) temperatures can range from -20°C to 85°C. Units should be allowed time to acclimate before being powered up.
Operating the players above 50°C ambient for prolonged periods may reduce the operational life of the product and result in intermittent resetting of the device.
Important
Exposing a cold player to warm air at high relative humidity may cause water to condense inside the player, leading to component failure. Damage due to such internal condensation is not covered by warranty. If a player is cold, allow several hours for it to acclimatize to ambient conditions before applying power.
Power Adaptor
The XD235 and XD1035 are supplied with 12V@3A power supply.
An additional 2A of power is available for peripherals connected to the player. The user should not connect any combination of peripherals that will exceed 2A draw. If more than 2A is drawn, the external power supply may shut down due to over-current conditions. The unit will not be damaged, but it may reboot or not operate properly until the overload is removed.
If the device is being powered by the power supply, the 2A can be shared in any way among the following connectors:
Connector | Maximum Power Usage |
|---|---|
RJ-45 | Approx. 180mA (when transferring data) |
USB 2.0 (Type C) | 1A |
USB 2.0 (Type A) | 1.5A |
GPIO 3.3V | 500mA |
HDMI® 5V | 70mA |
IR blaster output | 85mA |
M.2 Wi-Fi Module | 3V3 The combined power of these expansion ports should not exceed 3.5A |
M.2 SSD Module |
PoE Type 1Â
When the player is powered via Type 1 PoE, the total available power is reduced to 12W. This means that each USB port supplies 100mA of power (one unit load for USB 2.0). This is sufficient for low-power devices such as memory sticks and mice. High-power devices such as hard disks will not operate.