Set Audio

Changes the audio settings of a zone. Note that triggering the Set Audio command while an audio/video file is playing will cause playback to freeze (though the player will still respond to interactive events like Timeout, UDP, etc). You can also use the Set Audio command while displaying an image file, or you can attach the Set Audio command to an interactive event that transitions to or from an audio/video file.

• Zone: Specify the zone to which the audio settings will apply.

• Audio Output: Enable or disables the Analog Stereo, HDMI^®, and SPDIF audio outputs.

  • Pass through: Supplies the un-decoded audio signal through the HDMI/SPDIF connector. Use this option if the presentation audio (for example, AC3 Dolby Digital) is not supported by the player and is being decoded on an external device.

  • Stereo: Supplies the decoded audio signal through the HDMI/SPDIF connector.

• Audio Mixing: Specify the part(s) of the audio signal to send.

  • Stereo: Sends both left and right audio signals.

  • Left: Sends the left audio signal only.

  • Right: Sends the right audio signal only.