Audio Only Zones
- BrightSign TechDocs
The Audio Only zone allows you to play audio. Use the Zone Properties window of an Audio Only zone to edit the following:
Audio Output: Configure audio outputs for the zone.
Analog Stereo: Check this box to enable audio output via the 3.5mm audio connector (or USB Type C connector on the LS423).
HDMI: Check this box to enable audio output via the HDMI® connector.
Pass through: Supplies the un-decoded audio signal through the HDMI connector. Use this option if the zone audio (for example, AC3 Dolby Digital) is being decoded on an external device.
Stereo: Supplies the decoded audio signal through the HDMI connector.
SPDIF: Check this box to enable audio output via SPDIF.
Pass through: Supplies the un-decoded audio signal through the SPDIF connector. Use this option if the zone audio (for example, AC3 Dolby Digital) is being decoded on an external device.
Stereo: Supplies the decoded audio signal through the SPDIF connector.
Audio Mixing: Choose the mixing of the audio output:
Stereo: Outputs both left and right audio signals.
Left: Outputs the left audio signal only.
Right: Outputs the right audio signal only.
Initial Volume: Set the initial volume for audio files (0-100).
Minimum Volume: Sets the minimum volume for audio files (0-100).
Maximum Volume: Sets the maximum volume for audio files (0-100).
Note
The Maximum Volume setting will be overridden by other volume settings in a presentation, including the Initial Volume setting for the zone and volume commands attached to events or states.
